Brake/Hazard/Turn Signal Wiring Issues (1 Viewer)

Joined
May 13, 2009
Messages
67
Location
Tucson AZ
Thank you everyone for your help. I figured it out. I had the two pairs of GY and GO wires miss pinned on the turn signal switch effectively sending the brake input to the front lights and not the rear. I swapped those around and it fixed the problem. on top of that the fuse for the Hazards was blown and I didn't realize it because its in line and not on the fuse box. Everything is now functioning as it should.
 
Joined
Jun 24, 2003
Messages
190
Location
Vancouver, Washington
Thank you everyone for your help. I figured it out. I had the two pairs of GY and GO wires miss pinned on the turn signal switch effectively sending the brake input to the front lights and not the rear. I swapped those around and it fixed the problem. on top of that the fuse for the Hazards was blown and I didn't realize it because its in line and not on the fuse box. Everything is now functioning as it should.
Thats great news! Congratulations on your success!
 

Users who are viewing this thread

Top Bottom