kelly saad
Supporting Vendor
Hello everyone.
Many of you have seen my postings, offering bodywork and paint, and perhaps some previous work that I have done. I now have a new 2000 sq ft shop with a paint booth, so everything is moving along nicely.
This 60 had rusty quarters, inner fenders and a fair-sized rust hole in the rocker panel. The vehicle is disassembled thoroughly, and bodywork is near completion.
The project:
1. Cut out rusted quarter panels, and rusted areas of inner fenders & tailgate.
2. Rebuild/fabricate new inner fender sections, weld in.
3. Cut quarter panels down to desired size, weld in.
4. Replace tailgate.
5. Repair rust hole in rocker, weld in new metal, fabricate to fit.
6. Weld closed all holes in rocker panels.
7. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
8. Remove seam sealer in lower doors, treat surface rust, new seam sealer and paint.
9. Fiberglass reinforced filler on all welds/seams, then filler.
10. Rustproofing/sealer on all accessible, inner areas that were repaired.
11. Exterior paint, no jambs. wet sand, and polish.
View attachment 2277947
Many of you have seen my postings, offering bodywork and paint, and perhaps some previous work that I have done. I now have a new 2000 sq ft shop with a paint booth, so everything is moving along nicely.
This 60 had rusty quarters, inner fenders and a fair-sized rust hole in the rocker panel. The vehicle is disassembled thoroughly, and bodywork is near completion.
The project:
1. Cut out rusted quarter panels, and rusted areas of inner fenders & tailgate.
2. Rebuild/fabricate new inner fender sections, weld in.
3. Cut quarter panels down to desired size, weld in.
4. Replace tailgate.
5. Repair rust hole in rocker, weld in new metal, fabricate to fit.
6. Weld closed all holes in rocker panels.
7. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
8. Remove seam sealer in lower doors, treat surface rust, new seam sealer and paint.
9. Fiberglass reinforced filler on all welds/seams, then filler.
10. Rustproofing/sealer on all accessible, inner areas that were repaired.
11. Exterior paint, no jambs. wet sand, and polish.
View attachment 2277947