Looking to install a pto into this bullbar, As I don't have any factory brackets I will need to fab a bar & brackets for the rear of pto, directly to bullbar rail attachments
So far I can se the pto needs to sit at a correct height inside chassis rails in order for the shafts to clear the radiator and protector plate .
Hoping someone can provide some measurements on pto depth inside rails on a factory set up so when I fab up brackets etc , I do it once and not make a mess of the bar
So far I can se the pto needs to sit at a correct height inside chassis rails in order for the shafts to clear the radiator and protector plate .
Hoping someone can provide some measurements on pto depth inside rails on a factory set up so when I fab up brackets etc , I do it once and not make a mess of the bar
