Hello all,
I just received my Dual Front Cup Holder, from Brad at BH3D and was wondering what you all are doing with the PWR/2nd Switch, that gets mostly covered up by the holder. My initial thoughts were to relocate the switch to somewhere up on the dash but noticed that it is on a pretty short harness. Is there such a thing as an extension for these switches, or would I need to build my own? If trying to make my own extension, does anyone have PN for the Male and Female plug ends?
Any ideas would be greatly appreciated.
I just received my Dual Front Cup Holder, from Brad at BH3D and was wondering what you all are doing with the PWR/2nd Switch, that gets mostly covered up by the holder. My initial thoughts were to relocate the switch to somewhere up on the dash but noticed that it is on a pretty short harness. Is there such a thing as an extension for these switches, or would I need to build my own? If trying to make my own extension, does anyone have PN for the Male and Female plug ends?
Any ideas would be greatly appreciated.