So I'm posting here because we cannot get a good, solid answer.
Purchased thru Nitro as they highly recommend these if not planning on ever lcking the front diff. My friend installs it no issues but then the wiring. They come with a key tab to stop the magnet from spinning except there is no key hole on the magnet. Like pictured in the instructions. Which by the way are horrible.
The instructions look like they're about 50 years old and copied over 100 times.
Also the key spins the wrong way when torquing the bearing cap. Why?
This is what the "finished" product looks like. It's been sitting on his table since Wednesday as we try to get a better answer.
1 said it's fine and another said there should be a key hole.
Has anybody else run into this issue with Auburn ectd?
Purchased thru Nitro as they highly recommend these if not planning on ever lcking the front diff. My friend installs it no issues but then the wiring. They come with a key tab to stop the magnet from spinning except there is no key hole on the magnet. Like pictured in the instructions. Which by the way are horrible.
The instructions look like they're about 50 years old and copied over 100 times.
Also the key spins the wrong way when torquing the bearing cap. Why?
This is what the "finished" product looks like. It's been sitting on his table since Wednesday as we try to get a better answer.
1 said it's fine and another said there should be a key hole.
Has anybody else run into this issue with Auburn ectd?