Arb turn signal wiring. NOT. Help? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 19, 2014
Threads
3
Messages
9
Wow. I just finished installing a 03 Deluxe front Bumper on my 2000 LX470. It was pretty seamless except for this last detail. The instructions for the Bar say to check the instructions for the "surround" and the instructions for the surround say to check the instructions for the Bar. WTF? Has anyone else figured out how to wire these in. Do I need to use a multimeter?

In the mean time I'm using hand signals for turning.

Thank!
 
The ARB deluxe was never intended for the LX, so you won't find any wiring instructions. Break out your multimeter. It won't take long.
 
Why can't you just tie into the factory turn signal wiring?
 
Good question. I finished installing the bumper after the sun had set using a flashlight. I was tired and had caved in and drank a couple of beers at that point. The next day the sun came up. I could see. I switched two wires and voila! I felt victorious and kinda silly at the same time.

Thanks!
 

Users who are viewing this thread

Back
Top Bottom