Anybody have a non-USA carb rebuild kit part number? (1 Viewer)

Joined
Aug 4, 2009
Messages
7,467
Location
New Hampshire
OK, I'm exhausted from searching...

Does anybody know of any part numbers for an aftermarket non-USA carb rebuild kit? It's a Canadian carb manufactured 12/12/77. I haven't been able to find anything besides $OR.
 

John Smith

In the garage
SILVER Star
Joined
Jun 7, 2004
Messages
4,267
Location
Maryland
OK, I'm exhausted from searching...

Does anybody know of any part numbers for an aftermarket non-USA carb rebuild kit? It's a Canadian carb manufactured 12/12/77. I haven't been able to find anything besides $OR.

I am sure one of the carb gurus will correct me if I am wrong, but I am pretty sure there is nothing "Canadian" about your carb; and any kit for a 2F carb of your vintage will work just fine. The two carb rebuild kits I have purchased covered a wide rage of models.

KEM 15643
Hygrade 791B
 
Last edited:
Joined
Aug 4, 2009
Messages
7,467
Location
New Hampshire
I am sure one of the carb gurus will correct me if I am wrong, but I am pretty sure there is nothing "Canadian" about your carb; and any kit for a 2F carb of your vintage will work just fine. The two carb rebuild kits I have purchased covered a wide rage of models.

KEM 15643
Hygrade 791B

Oh, my carb is very Canadian, eh. And there is a difference (actually many differences) from the USA version of the same vintage.
 

UltraFJ40

ที่นี่และมี
SILVER Star
Joined
Sep 1, 2003
Messages
1,238
Location
Dito loob ng kubo kubo ko
I was gonna ask the same thing about my non-USA Aisan carb (Easter Island Model II version 5.01.71). :flipoff2:

I doubt there is any difference between a Canadian carb and the standard issue non-USA carb but I'm pretty sure thats the direction John was going with that.

I'd get a hold of Trollhole.
 
Joined
May 3, 2009
Messages
904
I just happened to glance at my 78 US carb and a non-US version of the same vintage the other day. I wasn't really scrutinizing but the only differences I noticed were the various smog ports and the TP. Other than that they seemed pretty close. I think that both carbs would use basically the same kit.
 
Joined
Aug 4, 2009
Messages
7,467
Location
New Hampshire
I just happened to glance at my 78 US carb and a non-US version of the same vintage the other day. I wasn't really scrutinizing but the only differences I noticed were the various smog ports and the TP. Other than that they seemed pretty close. I think that both carbs would use basically the same kit.

Nope. The bodies are completely different sizes. Besides, "basically" isn't good enough when rebuilding a carb!
 

Users who are viewing this thread

Top Bottom