Another roof rack question

Discussion in '80-Series Tech' started by Farley, Jul 15, 2005.

  1. Farley

    Farley

    Messages:
    52
    Likes Received:
    0
    Joined:
    Oct 27, 2004
    Location:
    Parker, Colorado
    I will be removing the factory rack on my Cruiser this weekend and have read through the past threads regarding what to do. I am planning on drilling out the screw heads with a #11 bit and will be plugging the holes with stainless 10/32 srews and sealing washers (after I wet sand the rust that I am sure will be there).

    My question is how long of a screw should I get - 3/4" or 1". Or does it really matter that much. Any info would be great. Thanks
     
  2. NorCalDoug

    NorCalDoug problems solved daily...

    Messages:
    6,293
    Likes Received:
    116
    Joined:
    Oct 27, 2003
    Location:
    uhhhh...duh...Northern CA
    I'd think the 3/4 would be better than the 1". Short enough to get the job done and nothing more. No reason to risk poking the headliner.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.