another fuel injector question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

moondog

moondog

Joined
Aug 25, 2006
Threads
43
Messages
139
Location
Down by the River
I just got my rebuilt fuel injectors back yesterday (thanks Seth!) and was wondering what gaskets need to be replaced along with them....the copper ones that go on the bottom of the injectors were replaced when they were rebuilt, are there any others that need to be replaced too?
 
My 1HZ has 120,000 klms on it. Where around my area (Seattle) can I get my injectors cleaned? Or, where can I buy new ones if I cant get them cleaned???
 
HZJ60 Guy said:
My 1HZ has 120,000 klms on it. Where around my area (Seattle) can I get my injectors cleaned? Or, where can I buy new ones if I cant get them cleaned???
Click to expand...


I don't know about up there - I'm down in California, I had mine rebuilt by seth (pvcruisers on here) there is a place in Oakland, CA called Diamond Diesel that can do them....you probably want to have them rebuilt and not just cleaned - I had mine cleaned and it did some good for a little while, but within a couple months after being cleaned they were leaking once again and I sent them off to be actually rebuilt.
 
Can you possibly give me a phone number or address to where I can get them done?

Thank you.


Tom
 
I sent mine to Seth, just send a pm to pvcruisers on this forum, I don't know his number.

The number for Diamond Diesel in Oakland is 510-532-8500 (more expensive, but faster turn-around rate).

You might consider sending them to BC, I have seen some of the guys up there mention where they got their injectors done and the prices seemed better than here in the states....I don't know where though, search around on here.
 
You must log in or register to reply here.

Share this page

Back
Top Bottom