- Thread starter
- #41
Engine off the stand on on to blocks which will hopefully allow me to bench run her in the near future.
Builds Another 12H-T build (2 Viewers)
- Thread starter Gengis
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Need to secure better. They torque alot when reved
- Thread starter
- #43
Agree 100% Roma
I intend doing a cross member on the front stumps, out of the same pirce of wood, which will extend a good foot and a half ( What the hell is that in metric) either side of the engine. The sump is a bit low for me to do the same at the back. But I will also do a good front/ back brace on both sides.
I hope my neighbours donr mind how it "talks", I'm just going to use a short piece of exhaust to get the fumes out of the garage. HA.
I intend doing a cross member on the front stumps, out of the same pirce of wood, which will extend a good foot and a half ( What the hell is that in metric) either side of the engine. The sump is a bit low for me to do the same at the back. But I will also do a good front/ back brace on both sides.
I hope my neighbours donr mind how it "talks", I'm just going to use a short piece of exhaust to get the fumes out of the garage. HA.
- Thread starter
- #44
The tooth fairy came today
reconditioned injectors and cleaned pipes.
By the way, if you have a 12HT and can't get the hose from the turbo outlet to the crossover tube, then order a 1HD tube and circumsise it by 18mm.
reconditioned injectors and cleaned pipes.
By the way, if you have a 12HT and can't get the hose from the turbo outlet to the crossover tube, then order a 1HD tube and circumsise it by 18mm.
