Aluminum tub seat mounting question

Joined
Mar 14, 2012
Messages
131
Location
Buxton, ME
I am working on dry fitting everything in my tub. I mounted the seat brackets in the holes that were predrilled from Aqualu. The pitch between the mounts is 500mm (19 9/16"), but the pitch between the mounting holes on the seats is 515mm (20 3/16"). Has anyone else run into this issue? I'm not sure how to make up the 5/8" offset I am seeing in the mounting holes.
1649969965806.png

1649969997093.png
 
Joined
Mar 14, 2012
Messages
131
Location
Buxton, ME
Aren't there left and right seat mounts? Are you putting the stock seats back in? There are a lot of seats out there that are more comfortable. I guess they will make it look stock.
I plan on changing out the seats at some point, but for now, the fastest way to get it back on the road is to use what I have
 

alberta mac

addicted but not cured
Joined
May 21, 2009
Messages
1,251
Location
Paradise Calgary Alberta Canada
Website
forum.ih8mud.com
Something you may over look is where your steering wheel is after mounting the seats. You want the steering wheel centre of how you sit. If not then physical handicaps may occur. You could possibly weld a plate to the bottom of the sear with a hole to feed the bolt into the tub seat connection.
 

Users who are viewing this thread

Top Bottom