jonharis
Adventure Imports
I'm getting ready to do this on my truck as the trailer has fairly significant tongue weight. I emailed Air Lift direct and got in contact with Allan. He had me measure the inside diameter of my rear shocks as well as the total height. I am running the Slee Heavy Springs. My measurements came out as follows, truck on level ground.
ID: 5.5" (this is a little tricky to measure on a spring)
Height 9.5"
Based on those measurements he recommended kit #60744.
I ordered here: http://www.amazon.com/LIFT-60744-Series-Air-Spring/dp/B000CFO0EU
I'm a little worried about this kit number because the vehicle it was created for is indicated as a late 60s Buick Skylark and Chevy Chevelle. Dan's #60755 has similar listings. I believe that width is more important than length (stop smirking) in this application so I'm going to trust the tech guy and order a set. I'll get back to you with my findings.....
[FONT="][/FONT]
ID: 5.5" (this is a little tricky to measure on a spring)
Height 9.5"
Based on those measurements he recommended kit #60744.
I ordered here: http://www.amazon.com/LIFT-60744-Series-Air-Spring/dp/B000CFO0EU
I'm a little worried about this kit number because the vehicle it was created for is indicated as a late 60s Buick Skylark and Chevy Chevelle. Dan's #60755 has similar listings. I believe that width is more important than length (stop smirking) in this application so I'm going to trust the tech guy and order a set. I'll get back to you with my findings.....
[FONT="][/FONT]
Last edited: