Replaced all four accumulators.
Emptied and filled reservoir, bled four corners and the height accumulator, until fluid stopped, installed globes, then bled air at the four corners, but not the height accumulator.
Should I have also bled "air" from the height control accumulator?
It now takes 30 seconds to raise from low to high...
Otherwise handles excellent. Pressures look good. All damping modes work etc.
Pressures
6.9MPA front
6.0MPA rear
10MPA height accumulator
Emptied and filled reservoir, bled four corners and the height accumulator, until fluid stopped, installed globes, then bled air at the four corners, but not the height accumulator.
Should I have also bled "air" from the height control accumulator?
It now takes 30 seconds to raise from low to high...
Otherwise handles excellent. Pressures look good. All damping modes work etc.
Pressures
6.9MPA front
6.0MPA rear
10MPA height accumulator