Aftermarket headlight installation - What did you do with these wires? (1 Viewer)

[CanuckS100]

Hey there, I just got these and unfortunately there's no installation instructions. I can manage everything else, but curious how folks wired up these two wires in the second image below? I am assuming they're for the halo lights and they need to be tied into an ignition or headlight circuit.

 

[aedgington]

I believe that's switched power for the "angel eyes" rings.

 

[CanuckS100]

I believe that's switched power for the "angel eyes" rings.

Yeah, I believe the same, but wondering where folks wired those to.

 

[aedgington]

Yeah, my fault. I went searching for a picture of the fuse box to finish that thought and got distracted and just hit send. There are a few blanks in the engine bay fuse box that you can just use an 'add-a-fuse' to, but I can't remember which one is switched and that thread/pic is a bear to find. I'll try to take a picture of it on mine in a bit.

 

[aedgington]

On the right. You need to either notch your fuse box so it closes or drill a hole with a grommet or something.

 

[CanuckS100]

AH! Yes, I see. And you just ground each side to an accessible piece of steel, eh?

 

[aedgington]

You got it!

 

[CanuckS100]

What fuse are you using? 10amp doesn't work (guess).

 

[CanuckS100]

Disregard my question, it's only drawing 1.1 amps, so I threw a 3 amp in there.
Thanks for the guidance!! Now installed!

 

[CanuckS100]

Disregard my question, it's only drawing 1.1 amps, so I threw a 3 amp in there.
Thanks for the guidance!! Now installed!