Aftermarket Bumper Torsion Bar Lift (1 Viewer)

[SteeleLC2000]

I put on an arb deluxe bumper and have noticed that my front end is riding lower due to the increased weight. 34” in the front and 36.25” which is 2.25” difference and then I looked up the oem difference and it was .75” differential, making me believe that I should adjust the torsion to increase 1.5” to get back to the factory setting. Didn’t know if anyone would agree to my math or are there cons to doing this?

 

[MountaineerLC]

My recommendation would be to measure from the fender to the center of the hub, front and rear. Once you get those numbers adjust the front so that it is about 1" lower than the rear.

 

[JunkCrzr89]

My recommendation would be to measure from the fender to the center of the hub, front and rear. Once you get those numbers adjust the front so that it is about 1" lower than the rear.

x2

 

[SteeleLC2000]

My recommendation would be to measure from the fender to the center of the hub, front and rear. Once you get those numbers adjust the front so that it is about 1" lower than the rear.

Great idea, thanks so much for the response! I’ll make sure to get it done!