Adapter ID help needed (1 Viewer)

[Drake2]

Can anyone ID this adapter? No markings on it.

Thanks!
D2

 

[zebrabeefj40]

Small block Chevy front engine mount. The 4 holes near the center bolt to the front of the engine block. The big holes on the ends sit on the stock Cruiser engine rubbers IIRC.

Nick

 

[Drake2]

Small block Chevy front engine mount. The 4 holes near the center bolt to the front of the engine block. The big holes on the ends sit on the stock Cruiser engine rubbers IIRC.

Nick

Thanks Nick!

 

[reddingcruiser]

Seriously old school. Nice wall art.

 

[Bear]

That'd make a helluva boomerang !

 

[Downey]

That was made by Downey Off Road Mfg for bolt-in Chevota conversions before Saginaw power steering conversions made us switch over to side weld-in front motor mounts. Problem was that motor mount bolted onto the Chevy V8 engine exactly where the power steering pump needed to bolt on.

 

[pbgbottle]

Reminds me of my old conversion ki

t

 

[Downey]

I remember machining those Chevy bell housings 100 per batch. When they started trickling in 2-3 at a time when we ordered 100 it became time for us to make our own aluminum 4 speed adapter bellhousings, then that let us use all factory parts (shift fork, shift fork pivot ball, stock t.o. Bearing, stock front bearing retainer, and much nicer slave cylinder mounting- - -plus very thick wall 360 degree full circle made the aluminum bell housing bullet proof.