A CUTTING we will go!!!!

  • Thread starter Slowerthanu
  • Start date
  • Watchers 0
Slowerthanu

Slowerthanu

Joined
Apr 23, 2002
Messages
1,323
Location
Bountiful, Utah
So, I decided I didnt need as much fender as I had, so I cut them up (never fear purists, one was bondoed to hell) and trimmed the rear a bit more for I intend to eventually run 38's with out anymore lift.

here are some pics, enjoy.

2521569.jpg

2521538.jpg

2521527.jpg
 
D

dobro

Joined
Apr 18, 2003
Messages
23
Cool pictures, but Is that a :beer: on top of your hood???

Dan.
 
Slowerthanu

Slowerthanu

Joined
Apr 23, 2002
Messages
1,323
Location
Bountiful, Utah
yes it is a beer, I enjoy a cold drink when I am working.

It's Squatters india pale ale (I usually drink Guinness or other dark beers) 6.0%. Good flavor and no unsightly aftertaste.
 
offcamber40

offcamber40

Joined
Apr 26, 2003
Messages
279
Location
Mountains of WV
Nice ride man! What do you have lining the lower section of the door edges? Hard to tell from the pics, and I am curious.. Looks like soft top material?
 
IDave

IDave

Joined
Jan 3, 2003
Messages
7,184
Location
McCall, ID
What do you have lining the lower section of the door edges?  Hard to tell from the pics, and I am curious.. Looks like soft top material?

Looks like the door edging material I got from CCOT. Same stuff?
 
D

dobro

Joined
Apr 18, 2003
Messages
23
Never had that beer ! But hey; Who doesn't (even at work!!! ). Anyway, I think you should get that 40 a good flat spring over. It will give plenty of space with those cuts even to run the new 40" MTR's.

Dan.
 
D

dobro

Joined
Apr 18, 2003
Messages
23
Forgot to tell you that once i owned a FJ70. At the beginnig I did a 4" lift. Then I decided to go for a SOA but with flat springs and only gained 2 more inches. Plus the comfort and the axle travel.

Dan.
 

Similar threads

Gun Runner 5
Replies
5
Views
285
Gun Runner 5
Gun Runner 5
ceylonfj40nut
Replies
4
Views
228
ceylonfj40nut
ceylonfj40nut
J
Replies
7
Views
479
SteveH
SteveH

Users who are viewing this thread

Top Bottom