After a few long weekends and lots of help from the IH8MUD community my HG job on my 96 LX is complete with all the trimmings complete, Water pump, hoses, belts, thermostat, fuel filter, injector clean and cal, etc etc. Big thanks to Idaho Doug's DVD which I watched a few times to make sure I crossed the t's and dotted the i's and CDan for all the parts. I had a few left overs but I needed them for my left over nut and bolt collection.
It started and ran with 1 issue that was not present when I started the HG project. An EGR issue surfaced which I'm working on. I did all the PM on the throttle body and intake so I know all the passages are clear. After reading a few posts it looks like another call the CDan is in order for a modulator and assorted other parts.
The homeless wire I speak of is attached. I don't think it was connected prior to the start of the HG. If anyone can identify it and tell me where it should be connected to I would appreciate it.
Again thanks to everyone on the forum. Its an incredible resource.
It started and ran with 1 issue that was not present when I started the HG project. An EGR issue surfaced which I'm working on. I did all the PM on the throttle body and intake so I know all the passages are clear. After reading a few posts it looks like another call the CDan is in order for a modulator and assorted other parts.
The homeless wire I speak of is attached. I don't think it was connected prior to the start of the HG. If anyone can identify it and tell me where it should be connected to I would appreciate it.
Again thanks to everyone on the forum. Its an incredible resource.