Wanted 80 series front axle housing (locking) (1 Viewer)

[swamprunner]

Location

United States

Know its a long shot but figured I'd throw it out there. Maybe someone put the high pinion in the mini truck and didn't need house.

I'm looking for the bare front housing only. Don't need the guts.

 

[Deathvalleypaul]

I have the center section of a locked front axle, tubes are cut off about 1 foot out from center. This is a fully factory locker housing from an FZJ80, but incomplete axle tubes and no knuckles. I was going to weld on new tubes and rotate the knuckles, but the project sold way before it was finished

 

[RivMan]

Location?

I should have one up in Michigan in a month or two.

-Rob

 

[Deathvalleypaul]

I am in SoCal. I have previously had a shop modify stock housings to accept the factory locker. We use a locker gasket to create a pattern for the cutouts needed and add the studs. I recommend bracing the axle if this is done. The gasket is available from the Toyota Stealership if ordered as a Lexus part.

 

[swamprunner]

Still looking. Not in a hurry. I've modified a handful of them to accept the locker 3rd. Was just hoping to find one to drop it into.

If anyone has one send me a pm
Thanks