Parting Out 76 pig $1-$1000,000 (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Hey Bob,

I drilled and tapped down from the top into the splined shaft, but the pot metal ( sleeve, cup ) still spun and chewed up the splines. I thought about drilling from the side, but it just doesn't seem to be the right way to fix this. The newer wipers are set up different like what Don posted, seems they don't have the problem like the older ones. Maybe someone could 3D print a stronger one or make one from some tougher metal. Splines are on the ID and OD. Something to think about.
 

Users who are viewing this thread

Back
Top Bottom