So I’m in the process of pulling out the fuel tank on my FJ55 to do a restoration and sealant in addition to replace all fuel supply and vent hoses. I’ve been reviewing the schematics to make sure that all the vent hoses get run to the correct place and as I lay under my pig today to make sure I had a visual of where everything would go I realize that my tank doesn’t look like the any schematics for the FJ55 I have seen.
My tank doesn’t have the fill hose, overflow hose, and all four vent hose connections at the same spot on the tank. It has a vent hose on each corner instead. Leaving only the fill and overflow connections together. Has anyone else seen this? Below is what I expected, but not the tank I have. My tank has the vent hoses on each corner, but is identical otherwise
My tank doesn’t have the fill hose, overflow hose, and all four vent hose connections at the same spot on the tank. It has a vent hose on each corner instead. Leaving only the fill and overflow connections together. Has anyone else seen this? Below is what I expected, but not the tank I have. My tank has the vent hoses on each corner, but is identical otherwise