I've posted in the trailer section, but I guess its a little bit slow in there... Anyhow this is an 80 Series specific question so I'm hoping that I'll get more luck here...
I'm trying to figure out what wire to splice into on the brake pedal switch. There appears to be 2 red and 2 green wires. The instructions indicate that I should be splicing into the cold wire. Access is rather limited, so if anyone knows off hand which one to use then that would save me some grief in trying to figure out which one is cold.
As an aside, has anyone spliced into an easier access location?
I'm trying to figure out what wire to splice into on the brake pedal switch. There appears to be 2 red and 2 green wires. The instructions indicate that I should be splicing into the cold wire. Access is rather limited, so if anyone knows off hand which one to use then that would save me some grief in trying to figure out which one is cold.
As an aside, has anyone spliced into an easier access location?