67 wiper switch wiring connections (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 9, 2004
Threads
264
Messages
3,601
Location
Cool Comfy AZ
I'm rewiring most of my 67 and currently going through dash /engine compartment wires. I'm trying to figure out which wires go where on the old rotary switch. Here's what I have:

20240705_171146.jpg


20240705_085255.jpg
 
Can someone take a pic of their switch or just tell me what wires go where? Also there's a black wire that disappears into the wiring harness on the windshield frame side. Any info on that?

None of my FSMs or aftermarket manuals show that wire.

Thanks!
 
 
Thanks! I found the correct diagram. That's the same issue I had that's mentioned in that thread. I have that same old FSM, but the switch connections aren't shown. They are now...
 
Can someone take a pic of their switch or just tell me what wires go where? Also there's a black wire that disappears into the wiring harness on the windshield frame side. Any info on that?

None of my FSMs or aftermarket manuals show that wire.

Thanks!

Can someone take a pic of their switch or just tell me what wires go where? Also there's a black wire that disappears into the wiring harness on the windshield frame side. Any info on that?

None of my FSMs or aftermarket manuals show that wire.

Thanks!

Can someone take a pic of their switch or just tell me what wires go where? Also there's a black wire that disappears into the wiring harness on the windshield frame side. Any info on that?

None of my FSMs or aftermarket manuals show that wire.

Thanks!

20240707_095439.jpg
 
Thanks, that's perfect. 👍
 
Think my black wire was for a CB radio at one time but idk

That hole with grommet is for the wire for the room light behind the B pillar on the driver's side.not sure when those started. My 9/67 which first month of the 68 model. My 9/64 FJ45LP-B has a room light from the factory as well.
 
"Room light" LOL
 
Toyota used Black, Red/Green and Red/Black for the "Dome" light wire at differnt times during the FJ40/45 production run.
From the harnesses I have autopsied, Black was used in the early trucks up to I believe 1967. Red/Green was used from 1968 on and the one harness I have that has a Red/Black for the dome light wire was probably a fluke. It was a 1973 harness.
 

Users who are viewing this thread

Back
Top Bottom