60 series front drive line

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I am thinking about flipping my front springs on my 40 before I weld on my ford shock towers, but I need to extend my front driveline and the best way to do this is a 60 series front drive line. ANyone have one for CHEAP or maybe trade (I still have that beer kit and some misc stuff).

Dan
 
If you want cheap, you really can't go any cheaper than a square front if you don't mind a little noise.
 
i have an extra driveshaft if you need one,,,not sure if it will be too long for yours though.
 
i have an extra driveshaft if you need one,,,not sure if it will be too long for yours though.

I am pretty sure that a front D/L is a bolt in deal for a front spring flip. If not, since it is a front shaft, It does not need to be balanced if I shorten it since I will never go faster than 15MPH in 4 with front and rear lockers. Or, there is should be a D/L shop in Hanford that could cut and balance it later.

I posted inthe general 40 section to confirm the front shaft.

I'll take your front line. Let me know what you need for it and are you going to the next club meeting? If not, we can work it out.

Send me a PM and let me know.

Thanks, Dan
 
I could be wrong, but I think the driveshaft that Bill has is not from a 60.
 
I just read TLCA mags article on lengthening drivelines. It might be easy enough to do that with my spare shafts. But with a 60, I need to only change the flanges and drill out the bolt holes a bit (from what I can find information about).
 
yeah...didn't get much sleep before i answered that... i have 2 4 runner/mini truck driveshafts
 
Hey man...gotta enjoy it while i'm single...lol... Seals are safely tucked away in the glovebox of my silverado...i may need a mercy roadtrip up here to get my runner going again though. P.S. Go see Cloverfeild...was Awsome
 
Back
Top Bottom