Wanted 4spd driveshafts (any model, 7/78-8/84)

[CruisinGA]

Location

United States

Looking for a pair of driveshafts from a 7/78-8/84 cruiser. FJ40 preferred as there is a chance of the right length but other models OK too.

 

[87FJ60 Sam18]

I have those in OH. let me know if you still want them

 

[crockett]

I have a couple ...Dave Looking to clean out some parts so give me a offer Dave

 

[CruisinGA]

Bump!

 

[jkdur728]

I have a few from a fj60

 

[CruisinGA]

@jkdur728 that would work. I need front and rear. Ideally I need shafts that have the lengths below when installed, if I can't find any that are close I can have a longer shaft cut down.
Rear 25 11/16"
Front 32 3/8"

 

[3_puppies]

the 81+ rear driveshaft is a different length than the 1980 and earlier.

 

[Living in the Past]

the 81+ rear driveshaft is a different length than the 1980 and earlier.

Believe only the back changed 8/80. I see the same part number for the front for both 1/74-7/80 and 8/80+. The rear 1/74-7/80 had a change 10/77. Not sure what that change is or what changed 7/78. Should be noted the flange pattern changed during 8/84.

 

[CruisinGA]

I am running a split transfercase and flipped springs front and rear so I need 78+ pattern and lengths same or longer than what I listed so I can just cut down and not have to re-tube.