4 speed tranny measurement needed please (1 Viewer)

[Downey]

I don't have a 1970's 4 speed tranny, I need the measurement from the front flat face/wall of the transmission (behind bearing retainer) to the far tip of the input shaft, and length of the pilot on the end of the shaft (in front of 10 splines). Many thanks

Jim Sickles
tojoproducts@aol.com

 

[EWheeler]

I don't have a 1970's 4 speed tranny, I need the measurement from the front flat face/wall of the transmission (behind bearing retainer) to the far tip of the input shaft, and length of the pilot on the end of the shaft (in front of 10 splines). Many thanks

Jim Sickles
tojoproducts@aol.com

If you don't get it earlier, I can get this for you this afternoon when I get home.

 

[Camotubebender]

*

 

[Downey]

Is the .902 the length of the pilot, and is the tape measure right on the 7” mark???

 

[Camotubebender]

Is the .902 the length of the pilot, and is the tape measure right on the 7” mark???

Yes .902 length of the pilot and just under 7"

 

[Downey]

Thanks for the help, now already have my new project blue printed