sleeoffroad
Supporting Vendor
Did not want to hijack the Hanna bumper thread but wanted to post a picture of the new receiver that works with our bumpers.
It requires cutting a whole in the rear crossmeber and removal of the tire carrier winch plate.
This could also be used on our older bumpers, however you would have to cut the hole in the bumper as well. All new bumpers have the cutout already there, instead of the 4 holes like the earlier ones.
Thanks to CDan that did this kind of receiver some time ago and sharing the info. Thanks also to UncleBen for allowing us to cut up his 40th.
It requires cutting a whole in the rear crossmeber and removal of the tire carrier winch plate.
This could also be used on our older bumpers, however you would have to cut the hole in the bumper as well. All new bumpers have the cutout already there, instead of the 4 holes like the earlier ones.
Thanks to CDan that did this kind of receiver some time ago and sharing the info. Thanks also to UncleBen for allowing us to cut up his 40th.