I recently bought 2 caps and 2 gears from gamiviti to fix the back/forward operation of my power seats. I successfully got the passenger seat operating again, but snapped the gear for the driver seat while pressing it onto the shaft. I reassembled the seat for now until a new gear arrives. When re-bolting the seat back to the body, all of the bolts felt much more difficult to fasten. I stupidly rushed through and forced them in. All four driver seat bolts are tight and there isn't any movement, but I'm worried what might happen when I take the bolts and seat back out to fix the seat gear again.
I bought 8 new bolts in case the bolts are damaged ( Part No.: 90119-10605, BOLT, W/WASHER ), but could the holes be damaged too and require re-tapping/threading? The seat is in a comfortable position right now; would you guys recommend I leave things alone for now or push forward? Is re-threading even an option on these holes?
I just got this new ride last week and am new to the forum. I tried to search for stripped bolts, but I haven't seen any other threads (no pun). Thanks in advance.
I bought 8 new bolts in case the bolts are damaged ( Part No.: 90119-10605, BOLT, W/WASHER ), but could the holes be damaged too and require re-tapping/threading? The seat is in a comfortable position right now; would you guys recommend I leave things alone for now or push forward? Is re-threading even an option on these holes?
I just got this new ride last week and am new to the forum. I tried to search for stripped bolts, but I haven't seen any other threads (no pun). Thanks in advance.