- Location
- United States
Top of the day!
1991 PZJ70LV-MRW
147673 KM or 91,759 miles
KO82 axles
Runs and drives, motor runs great manual trans shifts as it should
LHD
PO imported from Germany, currently MD Title
1PZ 3.5L 5-Cylinder Diesel Engine
R151F 5-Speed Manual (same as 1st gen 4runner turbo)
147673 KM or 91759 miles
24v
Motor runs great (oil filter, oil change, fuel filter changed within last 100 miles)
Frame is solid with minimal surface rust
Suspension needs replaced
PO cut a hole in roof, I will have lexan or marine glass put in prior to sale so it is weather tight (I have no clue why this was done, would be fun for varmint hunting)
PO resprayed the vehicle (looks like a maaco special)
Glass was replaced with Aluminum Inserts (very poorly executed)
Worn spots in driver side of vinyl floor and driver side seat
Surface rust on axles some some rust holes in rear and on wheel wells
I have a front knuckle rebuild kit included in the price
I do not see any recent timing belt work on the vehicle
The front light harness was cut halfway up the front driver side quarter panel
I'm debating to start a build or sell. the vehicle is also listed on Craigslist
Motor is strong, clutch is strong, trans is strong, and 4wd engages
Selling price is $9000
Going to take more pictures this afternoon, if you would like anything specific please let me know
1991 PZJ70LV-MRW
147673 KM or 91,759 miles
KO82 axles
Runs and drives, motor runs great manual trans shifts as it should
LHD
PO imported from Germany, currently MD Title
1PZ 3.5L 5-Cylinder Diesel Engine
R151F 5-Speed Manual (same as 1st gen 4runner turbo)
147673 KM or 91759 miles
24v
Motor runs great (oil filter, oil change, fuel filter changed within last 100 miles)
Frame is solid with minimal surface rust
Suspension needs replaced
PO cut a hole in roof, I will have lexan or marine glass put in prior to sale so it is weather tight (I have no clue why this was done, would be fun for varmint hunting)
PO resprayed the vehicle (looks like a maaco special)
Glass was replaced with Aluminum Inserts (very poorly executed)
Worn spots in driver side of vinyl floor and driver side seat
Surface rust on axles some some rust holes in rear and on wheel wells
I have a front knuckle rebuild kit included in the price
I do not see any recent timing belt work on the vehicle
The front light harness was cut halfway up the front driver side quarter panel
I'm debating to start a build or sell. the vehicle is also listed on Craigslist
Motor is strong, clutch is strong, trans is strong, and 4wd engages
Selling price is $9000
Going to take more pictures this afternoon, if you would like anything specific please let me know
