Hey all! Just thought I’d open this can of worms again. I’ve read quite a bit on the forums and watched a few videos by Otramm and 6th gear garage. I’m putting together my passenger side steering knuckle (first one I’ve ever done) and am 99% sure I have the shims back to where they were (one on top one on bottom). In the pictures below see what you think but I have tightened the bottom bearing cap all the way and the top cap to less than the torques spec values. There is still quite a gap and I am way High on the preload value.
Anyone recommend or have the steering knuckle alignment tool or should I try something else. The only thing I know to try is to go back a make sure that I have my bearing races fully seated and that’s all I know.
Any advice would be good. I’m in the Apex, NC area.
Thanks
Thomas
Anyone recommend or have the steering knuckle alignment tool or should I try something else. The only thing I know to try is to go back a make sure that I have my bearing races fully seated and that’s all I know.
Any advice would be good. I’m in the Apex, NC area.
Thanks
Thomas