Curtice
SILVER Star
I've searched around, but haven't found the answer. Most roll bar bolt threads have to do with mounting the bar to the tub. I'm looking to get my roll bar assembled. I powdercoated it, but got mixed up on my bolts and am not sure what goes where and the powdercoat needs to be cleared from the threads. I *think* I know what is correct, but didn't want to finish chasing the threads with a tap until I was sure. Below is a picture of the roll bar bracket with the welded nuts. Can someone confirm if I am correct on the following:
Assuming that is correct, does anyone know where to get the correct bolts for all of these? I'm fine just ordering something generic, but would prefer the correct bolts.
Thanks.
- Lower left nut (in this picture) is a 7/16X20 SAE for the seatbelt to attach
- I think the other 3 are all M10X1.25. (The middle and the right bolts would be very long to go all the way through the bar. )
Assuming that is correct, does anyone know where to get the correct bolts for all of these? I'm fine just ordering something generic, but would prefer the correct bolts.
Thanks.