dmaddox
SILVER Star
Long story (don't ask), but the short:
Rear, 77FJ40, brake hose that goes down to the axle housing.
1. Is that male end of the brake hose that screws into the "T" juction a M12X1?
2. Converted to SAE, that would be a TAD bigger than a 7/16, or .4375". Should be, since 12mm is .4724"
.51181" = 13mm
.50=1/2"
3. This conversion I am doing, my flex hose (assuming it is a M12X1) that male fitting is just a bit too small(going into the "T").
4. Should I go 1/2" or .50 (fine thread???)- since 1mm more than 12 would be .511" becuase going with a 7/16" would be even smaller than the 12, right?
Thanks,
Ragman
Rear, 77FJ40, brake hose that goes down to the axle housing.
1. Is that male end of the brake hose that screws into the "T" juction a M12X1?
2. Converted to SAE, that would be a TAD bigger than a 7/16, or .4375". Should be, since 12mm is .4724"
.51181" = 13mm
.50=1/2"
3. This conversion I am doing, my flex hose (assuming it is a M12X1) that male fitting is just a bit too small(going into the "T").
4. Should I go 1/2" or .50 (fine thread???)- since 1mm more than 12 would be .511" becuase going with a 7/16" would be even smaller than the 12, right?
Thanks,
Ragman