kelly saad
Supporting Vendor
FYI, This is labeled "11" because the other 10 are in the 60 forum. New to the 40 section here, so this is the first.
The project:
1. Disassemble vehicle, remove doors, top, fenders, and windshield.
2. Strip entire vehicle to bare metal.
3. Remove rear tub half. Disassemble and rebuild.
4. New quarter panels and any rusted sections of inner fenders. Likely will make new inner fenders.
5. Fabricate all new braces under rear tub section, and any other parts that are unavailable.
6. Sand blast remaining rust, treat bare metal with POR-15 Metal Prep and/or Zinc primer.
7. Exterior paint, B/C, wet sand, and polish.
8. Assemble.
The project:
1. Disassemble vehicle, remove doors, top, fenders, and windshield.
2. Strip entire vehicle to bare metal.
3. Remove rear tub half. Disassemble and rebuild.
4. New quarter panels and any rusted sections of inner fenders. Likely will make new inner fenders.
5. Fabricate all new braces under rear tub section, and any other parts that are unavailable.
6. Sand blast remaining rust, treat bare metal with POR-15 Metal Prep and/or Zinc primer.
7. Exterior paint, B/C, wet sand, and polish.
8. Assemble.