kelly saad
Supporting Vendor
The project:
1. Disassemble vehicle, remove doors, tailgate and hatch.
2. Strip paint to bare metal.
3. Remove doors, hatch and tailgate.
4. Close all holes in rocker panels from trim.
5. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
6. New lower door skin replacement panels. Sand blast remaining rust, seal bare metal and new seam sealer.
7. New quarter panels and any rusted sections of inner fenders.
8. New doglegs and rear section of rockers.
9. Replace A pillar gutter sections.
10. Remove drivers quarter panel (the entire back half) from previous accident.
11. Exterior paint, B/C, wet sand, and polish.
12. Installation of Cascade Audio vibration dampening package.
It looks pretty good and quite straight actually, and the previous owners painted it matte black. Once the coatings were removed, it was obvious that this one was previously crashed and beat up in various places.
1. Disassemble vehicle, remove doors, tailgate and hatch.
2. Strip paint to bare metal.
3. Remove doors, hatch and tailgate.
4. Close all holes in rocker panels from trim.
5. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
6. New lower door skin replacement panels. Sand blast remaining rust, seal bare metal and new seam sealer.
7. New quarter panels and any rusted sections of inner fenders.
8. New doglegs and rear section of rockers.
9. Replace A pillar gutter sections.
10. Remove drivers quarter panel (the entire back half) from previous accident.
11. Exterior paint, B/C, wet sand, and polish.
12. Installation of Cascade Audio vibration dampening package.
It looks pretty good and quite straight actually, and the previous owners painted it matte black. Once the coatings were removed, it was obvious that this one was previously crashed and beat up in various places.