timing cover

Hey guys, I have a 97 Land Cruiser w/ the 1FZ-FE. Has had a oil leak thats been slowly getting a bigger leak. I took it to a shop and they said it the oil pump gasket but not the front cover but the one behind the timing cover @ the oil pump.. Is it neccesary to remove the head to r&r the...

Hey!! Back at my oil leak project. My leak appears to be behind the timing cover backing plate right above where the oil pan joins the block on the drivers side. Hopefully what I’ll find when I remove backing plate is a gap in the gasket. My question to all of those in the know-based on the...

Hi All, I recognize there are many threads about this, but none that I've found seem to answer enough. I'm in the process of putting my motor back together, and when torquing the timing cover to what the service manual calls out, it pushed the gasket out. As other threads have suggested, I...

New 2f gaskets. $25 each +shipping - Timing cover gasket set - Oil pan gasket set - Lifter cover

Hey! Working on a timing cover leak and got the harmonic balancer and timing cover off. Serious groove in the HB. Big ding (looks like pliers?) on the lip of the seal well. Searching other threads says the HB can be re-sleeved? I’ve found a new Dayco HB online for $200. Thoughts? Motor has...

Getting a timing cover leak on my Land cruiser... garage saying it'll cost $9K AUD as engine needs removed due to how timing cover sits sandwiched rather than bolted in. any advice on how easy this is to do by self?

Searching for a clean timing cover to fit a 1982 2F engine.

Hi all! I am a new member and feel that I am ready for my first ever LC. Been looking around for a few months and found a few in my budget. Had one of them (2013 with 166k miles) checked out by Toyota dealership. 1. Timing cover reseal 2. Transfer case rear output seal 3. Transfer case fill...

Hey all! Thanks for your help with my last couple posts this week. I do appreciate it a ton. I just did my timing cover and now I'm finally finished sealing up my motor. I took pics before I tightened everything up. I did 2 layers of 'The Right Stuff' as well as a regular gasket. What are your...

Longshot: Anybody have a 2F timing cover gasket laying around? I ordered one Monday but it won't be here for the weekend and was hoping to finish off a project. Would need to be triangle area. :beer: Ramon

I posted this in my 1966 FJ40 Frame-Off Build (3rd Generation Owner) build also, but thought I'd start a new thread separatly. So @Rock40 and I need some tech assistance here on a sealing washer question. #92 on SOR diagram (below) is a lower bolt on the timing cover area that goes directly into...

Searching for a good condition Timing gear cover and backing plate and oil squirt-er from a late 2F years 85-87 out of a FJ60. Also need thrust plate and bolts, and possibly more if you're parting one ... Anyone parting out a late 2F ? Thanks. :)

Ive removed all the bolts from timing cover (85 60 w/2f). I have disconnected oil cooler hose brackets. Last I whacked the tc a few times with rubber mallet. Tc won't budge. Don't want to damage cover or score surfaces. What am I doing wrong? Any advice appreciated!Timing cover 1 by FJ60BigLou...

Pulled my F engine to replace gaskets and seals (I figured they were original from Jan '73). Imagine my surprise when I found one of the larger diameter timing cover bolts was mongrel (not std Toyota with indented head and captured washer) and one of the small bolts spinning but not...