throttle

Hello! I have a long term problem with my 99 LX470 (245k miles) similar to other problems described here, but maybe not 100% the same. Occasionally, upon starting I get poor throttle response as if I am not even pushing the pedal down at all. It will, generally, begin to accelerate after a few...

Greetings. 1995 FZJ80. I’d like to replace the throttle cable on my 80. It’s nearly 30 years old and the plastic sheathing is starting to deteriorate. I’ve done some searching on Mud & PartSouq and have found that part 35520-60140, the throttle cable associated with my VIN, is NLA (including...

How much slack is acceptable? I’d assume over time there may be some stretching going on even though everything in the pedal feels ok. Has anyone had to adjust?

Hi All, I've crushed my 200 2008, luckily with no injuries (pictures attached). The left suspension was badly hit and fully replaced by Toyota dealer, this include the Brake line, ABS wire, etc. We are almost done before sending it to the body shop where a 2016 facelift kit will be installed...

I have a '14 LX 570 that I think it has never been cleaned. It's now 183K miles. I saw this guy removed the throttle body on his Tundra; however, I don't know if for the LX 570 it can be removed like that and if I should even if I can. I've also watched the Car Care Nut guy and he said that if...

Looking for 1982 FJ40 Throttle Linkage and Gas Pedal. I do have the firewall bracket, but that is it. Thanks

Good morning everyone, Temps are getting cold here in AK. This morning was -30 F. I had the cruiser's (94) block heater plugged in all night. I let it warm up for 10 mins before I started the drive to work. After 5 minutes of driving, my throttle became stuck open at about 3000 rpms. It would...

I'm looking to return my 1977 back to the original mechanical linkage. When I got it it was set up with a holly. So I will need everything from the pedal to the carburetor including the bracket that bolts to the carb. The only component I still have is the bracket still attached to the firewall...

Gday, Is anyone able to post some detailed or close up photos of their throttle linkage on a toyota 3b with an inline pump Cheers, Alex

Okay, my rig has been running at about 1000 rpm since I got it running several years ago. I get terrible milage (around 8 to 10) and have been putting work into it trying to get it up to snuff. I have done several camping and road trips with it and have not had any real issues other than poor...

My TPS sensor was replaced at a local shop, but I do not believe they set it up correctly. They didn't have a manual, and it turns out that they didn't know as much as they said they did (long story). I have a blinking OD/OFF light; the error code refers to the TPS sensor. I'm also getting...

97 TLC. Essentially unmodified from stock, but massively reconstructed...frame swap etc, so if there is something wrong, its likely my doing. Yes, it ran before the teardown. So I've got the beast all back together from frame swap and professional head rebuild. Engine starts and idles...

I think this is the throttle position cable that goes to the transmission. Can anyone confirm?

Looking for $50 shipped. Came off a 1998 Lexus LX470 with 197k miles. No APPS, TPS or IAC is attached or included. No hoses or wires either. This is just for the throttle body itself. Thanks for looking! Payment: PayPal or Zelle

Due to an unfortunate accident on (12/21/23), all Maxbore business is on hold until further notice... Packages will be returned to sender. I hope and pray my uncle George will make a full recovery.

Hey yall, My 1980 fj40 does not have a throttle cable going from the gas pedal to the carburetor (currently replaced with a sniper) I have some mechanical linkages, as one does for that year, any guesses on how to mate with my sniper?

Hello all, How on earth do i remove the TPS from the injection pump? I cannot remove the screw closest to the engine. Is there a special tool? Ive developed shifting issues after an injection pump rebuild (very late shifts, extremely sluggish) and i suspect the TPS was reinstalled incorrectly...

Fairly new user (came across the site when I had to replace the barrel ignition rod and found some helpful posts/links) and I am at my wits' end. My problem seems to have morphed from the "intermittent crank-but-won't-start/loss of throttle" problem into a "car has trouble even cranking at this...

Hello. Today, as I was driving my 97 LX 450 up a long grade with the cruise control on, I felt what I thought was the engine stumbling, but then I noticed the cruise light in the cluster blinking on and off. Turning the cruise off and back on seemed to clear the issue; however, on the return...

Hand Throttle and bracket for 1965 FJ45 (I know it will be hard to find)