My mechanic says Toyota no longer manufactures these. He found them for $350 per servo and I am told I need 7 of them. A. Hoping you guys have a source. B. Hoping I don't need 7 of them.
my EGT temp sensor is being stupid and I would like to fix it. My assumption is that these wires don't have polarity as they are only looking for delta Voltage, but do they? Can't find what I am looking for in the FSM
Hello,
I am new on the site, I am sadly not a mechanic😬, and I recently bought a Overland rig on a Toyota Dyna 4x4 with a diesel 3l engine and a manual transmission and equipped with a temperature gage at the exit of the motor 😀
I know that these engines tend to overheat of pushed too hard, and...
96 LC. A343F. At the rear of the transmission is what I believe to be the second temp sensor. Green and yellow wires. Note one of them is broken. Is this a temp sensor that triggers the dummy light on the dash or something else? This will be a pain to repair. Hoping someone can tell me how...
Hi,
As the title suggests, I am looking specifically for a working 2nd generation (69/03-72/09) temperature gauge. Ideally not too grungy and it must work please.
Thanks
Hello everyone, (long time reader, first time poster)
I'm am going to change all the drive line fluids in the 460.
Have read a lot of artifices and watched a lot of videos on changing the transmission fluid.
I want to use a scan tool to check the transmission temp; don't want to use a IR...
I’ve done some digging but haven’t quite found an answer yet.
Does anyone know how to test or to remove the water temp sensor without having to take the entire pump or thermostat or whatever that thing is off? :)
I sure was hoping this would be a simple test and replace, but it’s looking a...
‘96 Lexus LX450, running the Wits End turbo kit.
I’m seeing water temp & oil temp readings from my JRP (Just Race Parts) gauge.
Water temps usually see is 5-6 degree hotter reading from the ODBII gauge (Scan Guage II) display. But the JRP water temp sensor is reading temps comming from...
Hope this dont get me beat. I have read a bunch of posts on this and have not read a for sure answer.
My March of 1970 FJ40 has stock guage with a later 2F engine installed.
Temp guage works backwards. Is the older F engine temp sender a sure fix? If so, a correct part number would be...
Hello Folks! I've always had a temp gauge that sometimes like to peg itself out above hot, even though the truck is running fine. It will do it maybe once every 30 minutes, for 30 seconds or so. Not that big of a deal, but I noticed yesterday that the fuel gauge did the same thing (pegged...
The weather in Texas is solidly around 105 in the afternoons right now. When my truck is idling, the AC starts to blow warm and the engine temperature starts creeping up. Coolant is just a little bit below the full line and when I’m driving, the AC blows cold all the time. Any recommendations?
1977 is running about 177° (infra red gun) at the freeze plugs when warmed up and idling but the temp gauge slowly moved all the way right as it warmed up. I think the gauge may be from a '79 (the amp meter is). Is the sender from a '79 different than a '77?
thanks
Does anyone know if the 200 series with multi-information display i.e. VX , SAHARA (in Australia) has an AT oil temp light. The Manual doesnt show one, but it is there on the lower spec GXL model?
Hi everybody, I crossed half of Europe, the Mediterrainean Sea and reached the Moroccan Atlas. What became obvious since riding the highways in south of Spain is the that the coolant temp rises on long-stretched up-hill sections.
Even more now in Morocco on the steep pass roads. It is 1/5 of the...
All-
97 HZJ80, 1FZ. No CEL, but water temp and oil pressure guages are dead. I've read the tech threads on them both, but again, no CEL. Should I bother? Is the water temp being dead keeping me in open loop and just going to dump fuel?
Fluid service this morning, plenty of oil. Radiator is...
Hey all,
I know this has been debating And argued and beat dead a million times but I’m here to bring it back up and hopefully some local dudes will have some input granted our climate is so “extreme” during these months. For context truck is a 1fz-fe 326k. Full coolant flush, fresh radiator...
Did my startup today and attempted breakin. My block temp read 245 at one point, and the head was like 260 for about a minute. Crept up very fast, and couldn't get coolant in without it regurgitating! We kept going for a few more minutes, Told my buddy to tell me when it was past halfway on temp...