tc

$3,250 OBOB. This came out of my 1970 Toyota Land Cruiser FJ40 transmission was rebuilt in the early 2000's and has less than 20k miles, also has a gear splitter for higher speeds.

I’ve been chasing an intermittent issue with lockup not engaging at highway speeds. I know there are general conditions that the ECU needs to see to enable lockup such as speed, oil and and ATF temperature, but maybe 50% of the time lockup does not happen when these appear to be met. When...

1981 FJ40 w/ a 5 speed. Rebuilding the transfer case (seals, bearings, input shaft, etc). I know there are threads on this topic, but maybe not with my specific setup? I have a transmission jack and any tool needed for this job. I do not see enough clearance to remove both the TC and...

Like the title says. Turbo R151F from a 1987 4x4 truck. Complete from Bellhousing to Transfer Case. No shifters. Would definitely need a rebuild, sat outside from PO. (stored inside a shipping container now). I'm in Apache Junction AZ (Phoenix). Shipping not really possible. Come and get it. I...

Any ideas on how to pull the mileage? Found a 2000 MY locally. Thinking about pulling the TC to rebuild to use as my core/donor for part-time spool (and maybe underdrive and 3.1 low). Would like to know how many miles are on it. No battery but can use a donor/jump box. Is there way to get to...

Have a a bunch of total chaos stuff and some stock parts. Maybe $2k worth of stuff. 18k miles on it. Zero off road. All highway. TC started squeaking a little bit. 4wheel parts said I could replace the balls or lubricate them. Decided to just swap some parts out as it was over built for what I...

Hey gang, Dropping the tranny/tc, what is the best way to support the rear of the engine so i can safely remove the propeller bracket on the tc? Using the windowsill 4x4 method Thanks for any wisdom you can provide... '76 - 40 '78 - Chevy 350 v8

Hey gang, Dropping the tranny/tc, what is the best way to support the rear of the engine so i can safely remove the propeller bracket on the tc? Using the windowsill 4x4 method Thanks for any wisdom you can provide... '76 - 40 '78 - Chevy 350 v8

The FSM (not the transmission manual) outlines this step prior to transmission installation but gives no value for the measurement. Does anyone know what this measurement should be? I don't want to be fighting with this tranny install.

Truck is a 1993 HDJ81 with an electronic A442F. Here's the breakdown: I had my injection pump rebuilt by a reputable shop and re&re'd by my normal guy (I just don't have the time to pull this otherwise I'd do it myself). Since the rebuild (which went well) my torque converter lockup, which is...

Truck is a 1993 HDJ81 with an electronic A442F. Here's the breakdown: I had my injection pump rebuilt by a reputable shop and re&re'd by my normal guy (I just don't have the time to pull this otherwise I'd do it myself). Since the rebuild (which went well) my torque converter lockup, which is...

I'm in the middle of a rebuild of a 1984 FJ60 transfer case and have discovered the Idler Gear needs replaced. The TC is stock with the 34mm idler shaft. Before I start searching parts vendors, wondering if any Mud members have one they could part with? Rest of the TC was in pretty good shape...