Hi everyone. I’m in need of a high low shift fork for my transfercase. Mine is pretty worn down on the sides. I’m located in central
California but I can pay for shipping. Attached is a pic for reference. Thank you in advance.
Does anyone have a source for this boot. Also need the square plug for bell housing where the timing pointer is viewed. Best source for rear main seal too.
I will be converting a 3-speed to a 4-speed, keeping the vacuum actuated 3-speed transfer case and under dash shift mechanism for hi/lo. It is my understanding that because the 4-speed is approximately 4-6" longer, I will need to extend the hi/lo shift linkage rod. I measured the diameter as...
Decided the battleship gray original paint on the shifter plate between front seats needs a refresh. Went mat black and with a mat clear coat. Multiple layers and a week drying time.
Dealer for those piss ant replacement light bulbs to switches and Drive shift. Clueless why Emergency Flasher...
Howdy-
Looking for a few parts for my 2008 LC. I need an original shift knob (33504-60241-C1 brown/black leather with dark wood), a wood trim steering wheel (45100-60620-E1 brown leather/brown wood), and lastly I'm looking for the console insert (58806-60080).
Just a few goodies,
Hey All- I've been thru 3 of the OEM $40 shift knobs for my t case in 3 years. They all suck and don't last long. The first one stripped out, the second split up the side and the 3rd one has stripped out also. I sure as hell won't buy another one but need to have a knob. Do you think that...
I just purchased a 2020 GX460 with about 40K miles. When I shift from Park (with my foot on the brake) to Drive or Reverse, the gear shifter seems stiff. Is this normal. Shifting from Drive to Reverse, it seems easier, but it feels like there is more resistance shifting from Park to any other...
I've a down shift cable question. Need to word it first. Anyways, just saying hi for now because i just joined. Is this where i should post my question?
Have this nice shift console it's gray and in very good shape. Two 12V power sources have been neatly installed in. Price $32 plus shipping. Best to email me shmukter@pa.metrocast.net
Anyone have a rough/jerk shift in their lx or lc, mine only happens when shifting from 5th to 6th gear (180kmph / 110mph) You can feel the car buck a little, it feels like taking your foot off the clutch pedal too fast on a manual car. Anyway talked to the dealership about this 3 months ago and...
So I was today-years-old when I discovered we can actually shift through a gear range after placing the 460 in 4Lo.
This topic came up with friends whilst driving offroad in Mammoth a couple of weeks ago and I just looked it up. I always thought 4Lo was a single gear/selection - am excited to...
Hi all,
Just hoping for some input before potentially blowing a lot of $. Late '95 fzj80 with a A442f.
I was driving along at 100kmh when my box Down shifter back to 3rd for no reason. Since then this has developed into not dropping back to 1st at traffic lights and has become so bad that if...
Last few months my Sequoia lock to shift out of park has failed and needed to push the bypass. First it was when parked in a hot garage. Which reminds my of the driver's power door lock on a 2000 100 series and 99 4Runner which happened when it was hot (PHX, AZ). It now happened when cooler...
Came off a 71 I parted, I think these are 71 only? firewall tube and I think the other is one of the tubes that go under the floor pan. The other was most likely too far gone.
These two are in good shape.
$20 plus the ride.
Probably $30ish to ship.
I will start by saying I have searched the 80 Tech Forum and read through five complete threads and partially through several other threads. All dealing primarily with a intermittent "No Start" issue which I do not have. Most deal with the Neutral Safety Switch (NSS) and or it's connector (p/n...