37x12.5x17 AT3 XLT. Load range D. 3500lb load rating. 10th week of 2020 manufacture date. No plugs, patches, damage, or other issues. These have been off my 2500hd pickup truck for about 2 months now. I got a smoking deal on a new set of Toyo ATIII that were supposed to go on my work...
Hello,
I recently purchased another LC200 and the previous owner put Toyo Open Country AT3 33x12.50r18 Load Range F's on the truck. I had the vehicle shipped and the tire pressure is all over the place. Fronts are at 33, LR is at 41 and RR is at 51. I don't have experience with these tires -...
Help!
So, I recently discovered a minor leak in my KZJ78 transfer case, and I was able to pinpoint it to the small oil seal at the top of the transfer case where the shifter linkage goes into the transfer case.
I managed to disconnect the bellcrank linkage from the selector shaft that...
So I was today-years-old when I discovered we can actually shift through a gear range after placing the 460 in 4Lo.
This topic came up with friends whilst driving offroad in Mammoth a couple of weeks ago and I just looked it up. I always thought 4Lo was a single gear/selection - am excited to...
I recently installed an old Toyota inclinometer in my 2000 LX470 to fill the empty space below my single DIN head unit. I know our trucks don't have a light to indicate 4 Lo, but does anyone know of a 12v circuit that is energized when 4 Lo is selected? The inclinometer has a "4WD" light that I...
One of the things I noticed in the launch video was a picture in the background with 2 shaded vehicles. One looked like a 2 door, modern interpretation of the FJ Cruiser. The other looked like the Land Cruiser version of the Lexus TX. Anyone else notice that?
Hello, I am taking my 76' FJ40 to the frame with intentions of building a reliable daily driver/"ultimate" off-road vehicle (I know this could mean different things for different people; I want the ability to beat on this thing, however, it will very likely never be beat on. Trails, backroad...
Hi guys,
I own a landcruiser 80 1997 turbo diesel automatic with a single factory fuel tank 90 liters (24 gallons)
1. Any idea where to get in USA a long range fuel tank to replace the factory tank?
2. If thr spare wheel underneath the body is removed to install an auxiliary fuel tank where the...
Hi Everyone, do you know of an aftermarket extended range fuel tank options for a 2013 Toyota Sequoia?
I've contacted the guys at TranserFlow, who make them for the Tundra, however at this time, they don't have any for the Sequoia.
They did offer to customize for the sequoia, as long as the...
It's been a few months that my LC's oil pressure gauge pointer would sometimes point to the lowest tick mark on the gauge, see attached photo, I was on highway today at a bit over 40mph, even when I was at 55, it was pointing to the lowest. What could be causing it? I remember before it always...
1993 FZJ80 White As It Sits Now.
Current MODS & Gear:
Engine Swap (Adventure Offroad 4.6L HO)
ARB AIR Lockers F/R
2x ARB HP Compressor Front & On Board Air Rear
Nitro 4.88 R&P Gears
AVM Hubs & Slee Part Time Kit
Factory Locker, Compressor & CLD Switches
Factory Hand Throttle
3.5" Autocraft...
Hi I'm a long time lurker and just joined the forum. I've had a few yotas in the past and finally am in a spot where I'm looking for a 40. I'm not opposed to a long drive to check one out but figured I'd post here and see if anyone has anything near Nebraska for sale. I've used searchtempest...
I just got a 2000 LX and have an absolute mountain of preventative maintenance to catch up on before i get to neutral pressure adjustments. I have two small children who id rather spend my time with so i only get about 30 minutes of maintenance time per night after they go to bed so its likely...
I'm about to tear into my case to part time it. I thought good opportunity to re-gear the t-case.. So I'm gauging interest to see if maybe a mass buy is possible for the Marlins gears. I would prefer the Marlin gears since they are made in Japan.
Not knocking those of you who have the Trail Gear...
As the title says, I have a set of used FROR heavy duty steering links for an 80 series. I converted to a Y-link setup last year and these are sitting in the corner of my shop.
Some light rust, but the links are strait.
If somebody really wants the TRE's that are on them they can have...
I am in the market for preferably a UZJ100. I am not overly fond of champange. Preference is Grey or Black. But will consider all within my price range.
Most importantly, I need to pay via Paypal to use my credit card. If you cannot accept this method, please don't bother.
I understand I am...
I know the pointer in the middle of the window is 7*, but does anyone know what the top and bottom of the window ends up being? FSM only mentions the 7* on the pointer.
Reason I ask is that I just finished up my AFI TBI install and they recommend the base timing be set to 0*. I have the mark...