Sorry guys I'm coming over here from the landcruiser section I have a 1991 4runner and wondering if there is a section over here to sell it or perhaps part it out ?
My apologies if this has been asked before.
Thanks
Tommy
Parting out my heavily modified 99 100 series. The improperly installed windshield killed the cab and being a New England truck killed the frame.
Front ARB bumper
Rear 4x4 labs bumper
Trail tailor creeper skid
Koni raids
ARB locked front diff
Rear factory locking 99 diff
Loaded knuckles...
Complete part out on my 97 Fzj80 40th anniversary edition due to rust issues with the frame. It still ran and drove into my garage and was my daily drive for a long time. 240k miles on it when parked.
Continuing to part put my 97 Fzj80 40th anniversary edition due to rust issues with the frame...
Bought from a local mudder. I just needed the injectors and fuel rail. I was going to keep the head to do a 2FE in my 80, but plans change. Alternator is dead, but AC compressor works. May need a clutch per PO. Alternator is dead.
5 good injectors.
$1250 takes it all or
$300 AC compressor...
@AndersonDin is helping with the rest of this part out. If you need something he or I will respond. If sending a pm, just copy both of us in the message. Thanks!
I’m parting out an 80 series in Oklahoma City, Ok. Anything large we can arrange either fastenal pallet shipment or pick up. Clean...
** I HAVE PILES OF 80 / LX450 PARTS JUST ASK **
It's been a long time since I started a new part out thread.
I've sold many, many, many parts 93-97 but now adding 91-92 & LX450 to the mix.
Please message me with specifics of what you're looking for.
I do ship SMALL parts.....but large items...
Parting out a White 1996 salvaged title (fender bender) lx450 No rust runs and drives well enough. Located in Salem Oregon about 40 minutes from Portland
also have a green 96 80 series shell that's basically a clean title frame and shell with a rear passenger door otherwise it is stripped but if...
I have two 24 volt 3B’s for sale in Wilmington NC. One has a crankshaft that has blown apart and the other started to knock from the bottom end. I can take individual parts off if anyone is looking for something in particular.
$700 for the one with a blown up crank.
Has a newish head on it...
Seeking 100-series parts for a 2006 LX470
I'll search individual parting out threads for potential 100-series donors, but thought it might be worth a post asking if anyone might have any of the following:
Rear view mirror, an ECU from the driver door, vapor (charcoal / evap) canister, or the...
My 80 has seen better days, I’m looking for front and rear axle assemblies. Preferably disc to disc. Rear shock perches are ready to break off rear axle due to rust, fronts aren’t far from the same demise. Interested in everyone’s opinions on the issue and task. Truck has 170k miles, runs great...
Los Angeles area - I just pulled and sold the head off the engine. Everything else is still here
PS pump with pulley $60.
Alternator (NOT HIGH OUTPUT) $500.
Good Used Starter $60
Freshly rebuilt starter Sept 2022 $100
EFI Manifold
Exhaust manifolds.
Valve Cover - Clean and not multiple coats...
Lots of parts of available pulled from a 1991 Toyota Landcruiser FJ80.
Dashboard x2
Lower front valance
Driver corner rear bumper. Pass side for parts only
Fuel injector wire harness
3fe headers.
Pass side headlight good. Drivers side no glass.
Gray carpet complete or pieces
Front Grille
Air...
Hey y’all, I’ve got a 1985 fj60 for part out.
So far, the items I’ve sold are : fuel injection system, dash cap, stock carb, rear seatbelts , back seat, headlight bezels (the new ones) window crank handles
Pull handle inside rear window.
Everything in the photos is still for sale, but if...
I am parting out a 1973 FJ-40.
See 100+ photos here
No drivestrain
Full hard top
Long jump seats
Rear barn doors (left one has rust)
Hard top sides are solid
Front hard doors are solid
Aftermarket roll bar
Frame is good
Hood is good
Front fenders have some rust, but not too bad
Complete...
*Update*
All remaining parts will be sold in a yard sale in San Diego this Saturday 8/21/21
https://forum.ih8mud.com/threads/80-series-parts-yard-sale.1261222/
My buddy and I are parting out a 94 Land Cruiser with a build date of 12/93 that ends it's life with 209,433 miles. It drove from...
Parting out a 1986 Toyota Land Cruiser FJ60
Dune Beige exterior
Brown interior
Door cards are excellent
Interior seats in good shape
Good center console
Lots of great interior parts
100+ photos here:
https://sigfridsandsons.com/product/1986-toyota-land-cruiser-fj60-dune-beige-all-original/
Posting for a friend.
Toyota Landcruiser and parts+++++
I visited this guys shop today and he has quite a haul. The 55 needs work but that is made up for by the fact that it is stuffed with parts he has acquired while restoring multiple Fj40s. The roof has ambulance doors and a hood stacked...
I am parting out three FJ-60s. Have a variety of parts, large and small. I can email pics and pricing. My email is SigfridsAndSons@gmail.com
Parts include:
Cluster / speedo / gauges
Body parts
roof cuts
Rocker panels
Lift gate
Tail gate
Windows
Brown factory bucket seats
Brown factory bench...
Parting out a 1982 FJ60 with only 148k miles. I've never turned the motor on this FJ over, but the previous owner said it had an engine knock. Pretty low miles on everything else including the t-case and transmission.
View 200+ High res photos
Please email me for parts availability and pricing...