overhaul

I have a 3 speed transmission and a 4 speed transmission. The 4 speed needs an overhaul and the 3 speed works. Asking 250 for both. Yon reach me by cell at 559-646-4422 or message. Thanks

Does anyone know where I can find these in good shape for a suspension overhaul? 78 FJ40. Thank you very much. Eric

I wanted to present this bit of info to the community as I think I discovered something that I have not seen mentioned and its something that alot of FJ60 owners might be struggling with. I have been unhappy with the slow speed of the wipers in my 1985 FJ60 for quite a while. After greasing all...

Good afternoon ladies and gentlemen, I am the proud owner of a 1984 HJ60 equipped with a 2H engine. As many of you might be aware, it's on the slower side. However, I plan on making this my lifelong car and envision undertaking a full restoration to transform it into a ski-van/doomsday vehicle...

I have for sale an unused and NIB Terrain Tamer Land Cruiser gearbox overhaul kit. From what I can see it is complete when compared to the Terrain Tamer website. Included is everything that you see. It is used to overhaul your 4-speed LC gearbox from 9/73-10/84. Message me with any questions $40

I have for sale a new unused Terrain Tamer TK4 transfer case overhaul kit. It is used on Land Cruiser transfer cases from 7/80-10/85. All parts are present when compared to the Terrain Tamer website. Message me with any questions. $85

I have an FJ62 88, 200k miles, body in great shape, but recent rebuild didn’t go well. I want to overhaul to make is a daily driver with highway speed, something to last for the next 20+ years. The Mosley high power rebuild seems ideal, but they are booked up...

On a recent trip back to Missouri from Michigan the engine suffered a catastrophic failure at 341,000 miles. I have to decide whether to have a remanufactured engine installed there, or trailer the LC back to Missouri and find someone to rebuild it here. Any advice as to reputable engine...

Hello, Selling a new diff install/overhaul kit for 1990 or older Land Cruisers. Part number is ZK-TLC-A from USA Standard Gear. Has Koyo Bearings, shims, crush sleeve, etc Asking $100.00 + shipping via Paypal (friends and family) Located is San Jose, CA Please PM if interested.

I bought my FJ62 in 2010, and have had overheating issues. Right off we diagnosed a blocked radiator made for high temperatures when you go above 2000 rpm. I had the core rodded out. Soon after the top tank started leaking. I had this resoldered near Timbuktu, again in Benguela in Angola, used...

I have searched and found references to folks that have pulled, cleaned, whatever, but no actual mention of taking it apart and servicing it. Anyone open one of these little gems up? I am having floating idle speeds and I have eliminated about everything except this. I have tested the valve...

Pretty sure this topic has been covered a several times but there are many ways to skin a cat as an environmental activist would quoute the abundance of options presented for skinning a f**n cat. Btw Jerry would have heaps of ideas how to take poor old Tom's fur off .. Here is this 1976 steering...

Ok, lets start by saying I'm kind of frugal...This means I had a hard time paying a lot of money for all new wiper linkage, when all that was wrong was $0.14 worth of plastic! I recently up graded to 4Runner wiper arms, and they are soooooo nice. I found them a Toyota wrecking yard with all the...

I'm in the process of a complete brake system overhaul on my '93 FZJ80. I had a near-miss in a panic stop a few months ago and have done a bunch of work on them since then, but they're still not what I would like them to be. As a part of the overhaul I bought 4 used calipers and am rebuilding...

So I overhauled my rear brakes this weekend. Now, I have a very distinct knocking/pinging noise emanating for the rear driver's side wheel. Noise seems to present each time the wheel rotates one full revolution, forward and reverse. Definitely gets louder when I depress the brake pedal. I'm...

I just got a Overhaul Gasket Kit from CC. However they don't identified any parts on the kit. My cousin is sending the manual from the USA and it will be here with in the month. Can someone help me identified these items Thanks Bill D

Hello, my name is Robert. My grandfather gave me his BJ40 (1978) long time ago. I been riding this monster since I was 13 years old. It has been on my family since I was born. (I'm 20) The thing is that, I started to get money to make an overhaul to the engine. (Last overhaul was 18 years ago)...