Hey all, I've been working on an LS/NV4500 swap on my 86 fj60 for a few years now and I'm wondering if anyone could help me figure out my T-case positioning/alignment. I was driving it for a while before I decided to replace the original motor mounts, bell housing, and now exhaust. In pulling...
Hey all I have a 6bt from an old backup fire pump that has an alternator with a 14.1v regulator. The stock alternator as far as I understand is set to 14.4v. Im hoping to chop up the old harnesses and still use all the factory wiring for accessories and sensors. Will a lower regulator voltage...
If anyone has any leads on where I may be able to find a 6bt to A442F adapter plate let me know. If not im planning on running a NV4500 so if anyones got one sitting around I may be intrested. Thanks.
I recently bought back a rig I had sold some 10 years ago and would like to start with changing out the trans. Here's my current setup:
1969 FJ40
5.3L Vortec (LM7)
SM420
3spd transfer case
2" body lift, SM420 didn't require any floor mods
stock axles
Primarily looking to get Overdrive or at...
And so it begins…
After looking for a while for a factory diesel Land Cruiser after talking with a fellow mud member. He slowly convinced me to go the 6bt route and do the swap myself. Soooooo… I bought a 1994 triple locked 80 series with a blown head gasket in semi decent condition with the...
I have a 89 fj62 that has been diesel swapped to a mechanical injected 6.5 turbo diesel. The engine has been mated to a Chevy nv4500 with an AA bell housing and the transfer case is out of a 60.
ENGINE.
6.5 diesel out of a 97 k3500, ARP head stud kit. New heads and injectors and head gasket...
This Land Cruiser has been in the family since 1978 and it has gone through multiple builds already. It currently sits on 35s, SOA, power steering, 383, SM 465, and a rear locker. The plan is to stretch it by 14”, replace the engine with a 6.2L LS, then install an NV 4500, Atlas 4, and 1 tons...
whats the odds someone still has one of these adaptors floating around they use to be made by advanced adaptors.
NV4500 4wd transmission to toyota 21 or 23 spline gear drive transfer case adapter from advanced adapters. advanced adapters part# 50-0215 or #50-0216 (only difference between to...
I just purchased a 1975 FJ40 roller. I'm building it into a daily driver primarily. I have zero experience but I'm working with a guy who has a ton of restoration experience with older 2WD cars. Plan right now is a R2.8 Cummins with an NV4500 tranny.
For sale new never installed Advanced Adapter flywheel and clutch kit 712500M.
https://www.advanceadapters.com/products/712500m--flywheel-and-luk-clutch-kit-for-ls-series--gen-3-engines/
Made to adapt an LS/3 Gen series to manual transmissions (M21/M22, SM420, SM465, NV4500).
I bought it with...
IM SELLING MY NV4500 TOYOTA SPLITCASE COMBO. THE TRANSFERCASE WAS COMPLETELY REBUILT(USING KOYO BEARINGS) AND MOUNTED TO THE 5-SPEED TRANSMISSION VIA ADVANCED ADAPTERS BY GEORGE FROM VALLEY HYBRIDS. THE TRANSMISSION WAS VISUALLY INSPECTED AND GIVEN THE THUMBS UP IN TERMS OF CONDITION AND...
4BT/SOA OVERLAND BUILD
https://youtu.be/cXqrr717LUM
January 10th, 2018
Fellow FJ60 Cummins diesel enthusiasts. I've followed IH8MUD for a couple years dreaming of one day beginning a diesel conversion in my 85 Landcruiser. I've been searching long and hard for a suitable donor motor still...
Hey Mud! Although I'm new to the forum, I'm a longtime lurker and Toyota truck enthusiast! I've been cruising the Classifieds, Craigslist, Autotrader, etc. for a rust-free FJ60 to do a 6BT/NV4500 swap into.
I just have a couple of questions.
1. Is a SOA required to fit the 6BT? - All of the...
All Items are brand new. Never used. Nv4500 29 spline diesel 5speed. Atlas 2 speed rt hand drop. 3:0:1
1350 yokes. 23 spline but also have new 29 shaft w seal and o-ring. t-case come w universal shifter. $3500. Also have adaptor to mate to SD33 for all you Scout or Patrol guys.
Hey fellas, I'll first give the rundown on the specs and then I'll explain the problem...
Specs:
1972 Toyota Land Cruiser FJ40
Chevy 350 (Crate motor from ~1999)
NV4500 (Early version with granny low)
Unknown Clutch (probably installed 58K miles ago when drivetrain was updated)
Clutch Master /...
So I am starting out with an 1995 FZJ80, that supposedly lost an timing chain and ruined the motor, that I got for $1000 and a 1994 Dodge 2500 6BT, NV4500, 4x4, that has a bad rear main seal leak and a bad throw out bearing, that I got for $2,000. The plan is to make an tough, reliable, family...
So no hope on getting an H151 in the US without unplugging the bank. So I'm left with three choices:
R151f (from 4runner or tacoma)
RA60f (from FJ Cruiser or newer tacoma)
NV3550 or AX15 ( Jeeps)
Let's assume that I have the bellhousing and transfercase adapter figured out (not yet but just...
I need an Advance Adapters kit 712579. It's the Dodge NV4500HD to Landcruiser 6 cyl (2f) kit.
I called AA and they no longer make the kit. If you have one sitting around I'd love to put some money in your pocket! I would still be interested if you only had the adapter plate, I'm sure I...