I’m in search of a front diff preferably 4 pinion 4.30. My 99’ front diff is starting to go out and I want to have a spare and have it ready to go in.
Looking for a used one, in working shape, not damaged. PM me with info if you can help or sell me one
99’ LC
Located in north Alabama.
As far as I know, Toyota got rid of the 9.5" front diff after the 62 series, opting for the high-pinion 8" instead, which as I understand it was essentially a minitruck diff, or at least adapted from one that was originally used on 3000 lb pickups with 80 horsepower. I'm curious what led Toyota...
Selling the old front differential off of my 100 series. Incorrect diagnosis on my part led me to replace the diff. The original diff does not have any issues. Has 170k worth of use, oil had no metal shavings. Can ship at buyers expense. Price is negotiable.
Asking $500
I have a factory front locker. Is the third member for the front diff the same on locked vs unlocked axles? I know the axle housing is different but I would like to know if I can swap in another complete third member. I want to keep my stock stuff and swap in a separate one with different gears...
Hey guys, so we've been in Colombia now for about 2 weeks, after shipping the truck from Mexico, we went through some pretty sticky mud in the somewhat dry lakebeds of the Guajira desert and did some dune driving and hitting mountain mud roads. But overall, no real difficult or heavy 4x4. I...
Front left. Right in front of the engine mount.
The black plastic box is the front diff vent, the one I'm wondering about is the vertical nipple/ barb.
What hooks there? I don't remember.
This is on a 96 Lexus. My 94 FJ didn't have it, or the plastic box either.
I'm planning on remote...
6 hours into a 12 hour trip, towing a 2,600 lb. travel trailer. I heard and felt a bang, much like a driveshaft thump or hard shift, but much harder. A few seconds later I felt a vibration and started to pull over. As I did both front tires locked up into a skid. The trans shifted fine, and...
Hey guys. I own a NZ new 1991 pzj70 and I’m having real trouble finding a decent full assembly front prop shaft that’s the correct sizing, As mine has worn where the two parts spigot into each other.
The distance from centre of uni to uni fully compressed is 580mm . Now this is where it gets...
I was almost done with my front diff fluid flush when the black plastic tip from the Mobile 1 75-90 quart fell into the front diff fluid hole.
Has this happened to anybody on here before? I saw a thread about a tip in the t-case, but didn’t find one on the front diff. Will the tip get chewed up...
Hi All, I've searched the forums and found lots about what to do once you've blown the front diff. I am hoping that's not the case. I bought my LX470 at ~200k, I'm at 230k and currently going through the PM's found here: 200k Service & PM - Suggestions? (Thanks a ton).
I decided to save the...
I just replaced hose and extended as far up as I could next to brake fluid reservoir. I had the typical fuel filter on it then took it off. right about same time the DS knuckle begins to leak.
Could there be some correlation there regarding a vacuum or a reason this would be caused by...
Would this worn rubber bushing have anything to do with rack and pinion? or is it only holding front diff?
I'm trying to diagnosis skid control coming on like it did before replacing rack and pinion.
I JUST got my truck back on the road after replacing the front differential, and installed the third with a dry gasket. Apparently that wasn't enough since it's dripping out of there (the bottom is wet and leaves a little half dollar sized puddle whenever I stop). I read about using FIPG instead...
Looking for at least one or two front diff side gears for a 91-97 fj80 also 89-95 4Runner and 90-95 p-up. Any of those will work. Any help guys would be greatly appreciated. Thanks Justin
So a few weeks ago I decided to pull my front differential on my 98 land cruiser and replace it with all new everything including an arb air locker. Well my friend was helping me and he just told me to tear it down and we forgot to mark anything. I bought an air locker, nitro ring and pinion...
Yes folks it's another thread on a broken front 100 series diff! I just broke mine yesterday afternoon during some (mild) wheeling. Knew I needed to install a locker at some point but just wasn't ready for it yet....guess now I am!
So as I searched I found plenty of posts about folks trying to...