disconnect

I have a new in box kit from LCP. I ran Timbren bumps up front that weren’t compatible with the kit. $100 plus shipping. https://sites.google.com/site/landcruiserproducts/sway-bar-disconnects

If your Sunroof Fails Open you have a Problem. Pushing the Glass while Pushing Glass helped get it Closed. The Map Light (Constant 12V) and Moonroof Controls are in Same Plug. Preference was to keep the Light while Disconnecting Roof Controls but leaving everything Present. Roof Could be...

Hey guys. New LX470 owner here. I’ve looked all over the forums and haven’t found anything definite on how to disconnect the power antenna. Some say you can access through the glove compartment/cabin air filter area. Some behind the passenger wheel liner. I’m just hoping for a little more...

Hi all! Are there currently any solutions for extended sway bar disconnects for an FJ62 with a 2" lift?

Hello all, so for the second repair ever on my truck I am diving deep into the Head Gasket repair. I am actually looking forward to it as its a great way for me to learn about my engine, cooling system etc. One of the reasons I got and LC was to learn and be able to maintain it myself.:) I...

I just wanted to let everyone see the the disconnect mod evolution that I found after using a solution posted here by @Hayes. In his post was a two part modification. In brief: Part one was drilling out the captive threads for the bolt that hold the front sway bar link to the lower control arm...

Hey folks, I've seen threads for people using the blue sea m-lvd (low voltage disconnect) for accessory loads like fridges. Would this also work for all loads? I'd like something like this that would also work if I leave a dome light on or similar. Any ideas? This is what Google produced...

What is the consensus about using or not using the factory sway bar. I have heard some say lose it and others say its unsafe and use quick disconnects for sway bar when off road. I am running the 2-3in lift from toytec with bilstein 5100s and eibach springs. Does anyone out there have...