diff breather

  1. EsbenDenmark

    Resistance when blowing into diff breather??

    I am having a leak in my front differential and I am wondering if it due to too much resistance in the diff breather. I have installeret a original diff breather but I was surprised to feel quite a bit of resistance before I felt the little diff breather "open up" (blowing air into the tube like...
  2. AlexatWagan

    Extension for diff breather line

    Twice now I’ve noticed the line connecting to the rear diff was unplugged. That leads to tell me that the line isn’t long enough at that spot. Can someone refer to me a part to replace that line? It’ll be a good time for me to extend the breather line up higher, too. Thanks!
  3. Pulgasari

    Preparing for water crossings - what mods do I need?

    Hi everyone, I ran some trails with standing water (roughly 1-5ft deep) this weekend for the first time. Although my LX was fine, I knew I didn't have diff breathers or anything else beyond a snorkel, so I was on edge the whole time and picked the shallowest paths, which were about 1-2ft deep...
  4. Stingray

    Stock diff breather loose on top?

    Went through some crazy puddles today about 2 feet deep. Some I went fast to where water went over my hood but the rest I went slow. Should I be concerned about anything? The diff breather on the rear is loose on top not sure if that’s normal. Or if I should do a diff fluid change or tran fluid...
  5. Ironman 4x4 USA

    Winching Tips & Tricks 01 - Winching A Tree Off The Trail

    Often in backcountry travel, we come across a downed tree across the trail. We take you through a basic tree removal winching scenario using our 12,000LB Monster Winch and Large Recovery Kit. Having the right equipment outfitted to your vehicle is important but investing in training and...
  6. 9

    Front diff

    so ive had an issue where my front diff fill bolt is completely stripped and i cant remove it. Is it possible to drain my fluid out the bottom then add fluid from the vent hole if i remove the vent line fitting?
  7. JohnnyFish

    Overland Bound: When a Toyota R&D Engineer Builds and Overland Rig: Extended Cut

    Very interesting discussion of the Dan Rich's 80, the TRD supercharger prototype rig, in the wild.
  8. J

    40 Series Breather Locations

    Hello i plan on extending my breather lines on my 1980 FJ40 up to my engine bay and need to locate where the following breather points are; Front Axle- Already Found- Pretty starightforward Rear axle- Found. But have no clue on how to fit a 1/8 BSP fitting there as it appears to be connected...
  9. linuxgod

    Diff (and other) Breather Extensions

    I ordered the Dobinson snorkel yesterday... @crikeymike convinced me to pull the trigger when he said they only had one left and the next batch wouldn't be in until summer. Thinking when I do the snorkel I should extend any breather tubes at the same time. Anyone know how many need to be...
  10. Bear s

    Fzj 80 the romanian approach

    Hi there fellow mudders! For quite some time now I've been watching you from the shadow and I have finally decided to share my own Land Cruiser experience with you. As a small intro my name is Cristian I'm a 22-year-old guy that lives in Romania, eastern Europe and that's how I ended up here...
Back
Top Bottom