charcoal canister

I have a 93' 1FZFE Cruiser that I am replacing lines to the charcoal canister due to gasoline fumes in the cabin. I already swapped my canister recently for a VC120 which fixed pressurization issues, but the fuel smell in the cabin is bad. I changed the line to the tank with no issues, but when...

As per photo $125 shipped

I have 3 charcoal canisters for sale $75 each includes s/h (lower 48)

82121-60343M - Wire Harness 1997 TLC replaced to install SC all clips are working, removed with high attention to detail $300 17881-66080 Air Intake Hose, less than 2 years old, less than 5000 miles $75 22250-66050 MAF 150k miles, working when removed less than 4 weeks ago. $125 53101-60130...

Installing a charcoal canister into my de-smogged 2f. It seems straight forward but I am trying to figure out where this fitting goes to? I think it should go to a hard line that goes into the engine bay. But I can’t find it. Does the hard line run under the tank? First picture is of the fitting...

I took what I thought was pretty good pics of how things were prior to disassembling everything. Apparently, I didn't get good pics of where this vacuum line went. This is on a 1973 FJ40. I have narrowed this down to going to the charcoal cannister on the passenger side. From the other pics...

2002 LX 470. 275,000miles. No check engine light. We got to the mountains a little while ago. Easy FS road. Started smelling gas. Pulled over to find the CC buzzing and venting. Am I ok to drive it this way. I’ve worked on cars a long time, but this is a first. Any input is appreciated.

I have a friend with a '95 80 I was hoping to get some help with. The fuel filler neck had just just been replaced after running for a very long time with holes in it. Here is the description of the problem: "We got fuel in it, ran it for a bit and then sitting overnight we have fuel dripping...

I'm going to relocate my charcoal canister from the OEM location to next to the driver side chassis rail or on top of the tranny cross member. I need that space for other things, now that my ABS is gone. I'm curious if anyone is using a different style of canister, perhaps a rect shape from a...

Hi, I have a 1FZ-FE and believe the charcoal canister is blocked. Bad fuel economy and over/under pressure when opening the fuel tanks for filling. Has anyone experienced a blocked canister and how negatively did it effect your fuel economy?

Was it here? I remember reading the post somewhere but nothing on the search and forgot to save it.

Has anyone every used red line cruisers charcoal canister bracket before below?Just wanted some feedback on it. Thanks https://redlinelandcruisers.com/shop/engine/rl1006-charcoal-canister-heater-mount-1974-1984-fj40-toyota-land-cruiser/

I’m looking for a functional and as clean looking charcoal canister for my 74 FJ40. The part number I need should be 77740-60011. Located in Woodstock,Ga

1982 FJ40 V8 conversion getting high fuel fume smell once tank gets hot. There are 3 hoses coming out the top of the tank and going in to a fuel separator (which has a crack in it) and then one hose coming out of the fuel separator. I assume this exit hose ran to a charcoal canister when it had...

Hey All I have a 1975 FJ40 (left-hand drive) and I'm getting close to the finish line of a long resto. At the moment I'm reconnecting the charcoal canister/evap system. It's been so long since I took everything apart that I can't recall where/how the canister mounts under the hood. I have an...

UPDATED: PRODUCTION BRACKET Have you been putting off replacing the charcoal canister due to the "forever-out-of-stock" factory Toyota Charcoal Canister? We made a solution for that as we've made the Charcoal Canister Heat Bracket specifically for this purpose and specifically to fit both the...

UPDATED: PRODUCTION BRACKET Maybe you have been putting off replacing the charcoal canister due to the "forever-out-of-stock" factory Toyota Charcoal Canister? We made a solution for that as we've made the Charcoal Canister Heat Bracket specifically for this purpose and specifically to fit the...

Hey all, Replaced the OEM charcoal canister with an ACDelco 215-153 unit about a year ago (using this thread and this thread) due to tank over pressurization/ the "woosh" sound issue, (plus my canister was rusted out) which solved that problem. Been chasing a raw fuel smell on the passenger...

Could anyone help me with a Toyota part number for this hose (with faint yellow band) that’s in front of the vapor canister on a 01 LX470? I noticed there’s a large crack in mine. I live in the Bay Area and the stealerships in my area have no clue. I’ve also tried a bunch of online oem sites...

I currently am running a 2F with a Howell Efi conversion in place. I would like to Incorporate a simple evaporative emmissions system from a 1992 3VZE if possible. (Or a similar basic system) What do you think ? Can I simply install a Bimetal Vacuum Switching Valve (BVSV) in a location...