abs sensor

Looking for a front drivers side ABS sensor for a 1996 80 series. I don’t need the harness, just the sensor. It was broken during a knuckle service by the PO. Thanks!

I have a random ABS sensor and harness off a FZJ80 rear axle I used for a swap in my 60 series. $40 plus flat rate shipping.

97 Land Cruiser restoration. Installing new ABS all around. Rear has options for two different sensor kits for each side. Which yoke is correct? Don't see it mentioned in FSM. 04895-60020 YOKE L=52.6 04895-60030 YOKE L=53.1

Hello all I have a 98 that I purchased in February in Texas. There was an issue that led me to replace the master cylinder assembly. All has been fine with brakes until recently. A slight leak coming from rebuilt assembly - which was fixed meanwhile my mechanic tells me that MBCA is fine and I...

I ordered replacements that were supposed to be compatible with my 2006 LC. I went to replace them and noticed they are different than the ones already on there. They came without the harness. The current ones on the truck have more of a pronounced cylindrical stub (see attached). The...

So the ABS sensor on the driver side wheel is sticking out of the hole it goes into by about 1 cm. I recently did bearings and CV axle and that meant removing rotor, dust shield and the ABS sensor in question. When putting it back, I think I messed up by putting the oil seal for the dust shield...

ABS was working when I removed. These came off my 1996 FZJ80 with 119,000 on the clock. Front and rear sensors and complete axle to body harnesses. Looking at whats out there, I am thinking $200 shipped. ;)

Looking for front left and back right sensors. Anyone parting out?

Hey all- Recently took possession of a 2000 LX470, knowing it had this issue with ABS. Previous owner had it diagnosed at dealership being bad transfer case but the issue seemed more isolated to the ABS system, at least to me anyway. From a full stop, ABS engages when accelerating and would...

Brand new here- hope it posts in the right area. For my '94 Cruiser. Located in Colorado, 80915.

Anybody know the ABS Sensor O-ring part number or something equivalent ? (Front) I was told it only comes with the a new sensor Thanks !

Looking for best way to approach/troubleshoot where the issue is..right front or right rear sensor showing open. Not sure if it's the sensor, connections, wiring harness to sensor. First step thought to get ohm meter, put to sensor to see if/where there is drop in power. was careful with sensors...

Broke a front ABS speed sensor doing my Birfs. :doh: The question is can I just replace the one? I found some used and would only replace the one if I don't need to replace the pair. Thanks.