Starting problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 8, 2006
Threads
35
Messages
127
Ok, i was backing out of the garage this morning and seemed like it was running fine so i backed into the driveway and it died. Started it up again and gave it a little gas and backed out into the street. It died again. This time when i tried to start it, it dragged a bit then died, tried again and it just makes a clicking noise. So when i turn the key the engine makes no noise, just a click from somewhere. Any idea what the problem is? I do know we have a bad ground wire cable coming from the battery that has almost burned through itself at the bottom. But my lights/radio still work so i dont know if its the battery. It has always dragged starting it since we have got it, could the starter have gone out? Its a 79 fj40 by the way.
 
I just had a similar adventure yesterday that turned out to be corrosion in a battery wire terminal connection. Probably easier to check for corroded connectors first, rather than the way I did it: changing out starters and batteries.....:rolleyes:
 
the other guys are probably more correct in diagnosing your problem, but ***just make sure you've got gas in the tank***

Don't laugh....it happened to me because my gauge is bad.
 
jmode said:
Ok, i was backing out of the garage this morning and seemed like it was running fine so i backed into the driveway and it died. Started it up again and gave it a little gas and backed out into the street. It died again. This time when i tried to start it, it dragged a bit then died, tried again and it just makes a clicking noise. So when i turn the key the engine makes no noise, just a click from somewhere. Any idea what the problem is? I do know we have a bad ground wire cable coming from the battery that has almost burned through itself at the bottom. But my lights/radio still work so i dont know if its the battery. It has always dragged starting it since we have got it, could the starter have gone out? Its a 79 fj40 by the way.

My friend I had and have the same problem, on my fj, the PO had installed a push button start due to the key start making the clicking noise and not starting. Mine does the same thing, makes a click noise but the engine does nothing. Toyota told me it was my starter coil? However, my starter is brand new. Therefore I did some investigating. I saw that the PO had spliced the the wires that were coming from the starter in two directions, on to key, and one to the push button start. Toyota told me since my starter was so knew that it might also be because my starter was split two ways. Make sure your wires are not old or anything. I have'nt tried to fix it because I don't know what to fix. Meanwhile I am using the $3.00 push button start for everytime my key start fails. Weird enough, the push button start never fails, ever. I am going to follow this thread and see if it will help me. :idea:
 
i replaced the bad ground wire today. Still the same problem. I also noticed today, the wire coming out of the top of the starter to the soleinoid(the heavier looking wire)is pretty corroded. I also talked to some people at an auto store and they said it could possibly be the alternator too, but i think the corroded wire gives it away. I cant decide if i should just replace the wire, part of me wants to just get a new starter.
 
Use a jumper cable to bypass the hot wire from the battery to the starter.
 
Take a jumper cable and hook one end up to the big hot post on your starter and the other end onto the positive terminal of your battery, then try to start it. This way, you bypass or supplement your battery-to-starter wire. It will take just a moment to try. Clean your battery posts by taking off the terminal, wire brushing, and popping the terminal back on, as well.

You said you saw corrosion around the terminals. Your battery may be sending enough juice (amps) to light a light bulb, but not to spin your starter. This can be because of the resistance of a corroded terminal at either end of the wire.

Also, before replacing the starter, if you have it out, take it in to NAPA or someplace like that and they'll be glad to test it for you (free). Could save you a few bucks.
 
I know it's an older thread, but just to add my $.02

Yesterday, I had a similar experience as listed by jmode in the original post. My 1977 FJ40 was running fine, I stopped at my storage unit to load some parts and when I tried to start the FJ, all I got was a single, audible "click."

After some research on the forum, I decided to try the least expensive option and replaced the hot battery cable. Once replaced, the FJ fired right up. (I had a new ground as well, but haven't installed it yet.)

The morals of this story -
1. Spend time reviewing posts on the forums before spending money - you'll end up saving both time and money.
2. Wiring does fail
 
Investing in a good test meter and test light will save you much money. Sometimes you can chase your tail for days and spend alot of money for nothing. Thats why they invent these great tools. :)
 
Back
Top Bottom