XD9000 ARB mount question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 25, 2004
Threads
37
Messages
86
How do you mount the control box? I can not find anything in the directions for either the winch or the ARB winch mount kit and looking I can not see anywhere the mount would bolt to. Help appreciated, tried searching.
 
How do you mount the control box? I can not find anything in the directions for either the winch or the ARB winch mount kit and looking I can not see anywhere the mount would bolt to. Help appreciated, tried searching.

There is no set mounting location. I had to make a bracket and even that left it exposed to mud from beneath. You have to search for pics here and get creative. I my next one, I am mounting it under the hood and running a relay to a dash switch.
 
I thought it came with a kit consisting of large hose clamps and a bracket that attaches to the winch motor and the control box. Just went out and snapped a couple of pics of mine, don't know if you can tell exactly what I am talking about but here it is:
Winch.webp
Winch2.webp
 
Really no right or wrong...Some have mounted the control box under the hood, some directly on the winch, and some somewhere in between.

When my XD9000 was on my FJ40 it was mounted to a vertical bracket that was attached to the winch mount. When I moved the XD9000 to my LX I initially just zip tied it to the winch motor and then a few days later went and picked up some large hose clamps...Do a search on XD9000 and you should get some more pics (including mine) but here are a few to get you started...

.
FJ402 006.webp
7.webp
9 brightened up.webp
 
i have to figure out how to wire up my 9000.... i bought it used with no instructions...

anyone have wiring instructions?
 
There is a piece that came with your ARB that is for the control box...you may have to drill holes to fit your specific box.

I bought a bracket from Warn...it was ~$10.00...you remove one of the long Hex bolts that connects the winch together lengthwise...put the bracket on and replace the bolt...and it fits right to the control box.

But I'm sure you could fab up something...
 
Back
Top Bottom